How to replace a damaged, scratched, or chipped Luxury Vinyl Plank (LVP).
Cut it out with an oscillating or circular saw set at the right height; it’s going to cause a lot of debris, so make sure you have a vacuum on site when you do this.
Then remove the damaged piece, clean up underneath really well, and free of debris. Cut the new piece to the proper length. Cut off the bottom grooves of the new piece. Use glue on the tongue side of the flooring that’s down already.
Insert it, then use a rubber mallet to hit it into place, and Boom! All fixed.
source
Fuck the hole what if they want a outlet again
What glue. And why not some pl premium on the board as well…
What glue is that u use
Wat kinda glue
Do you guys have the tongue or the groove facing the starting wall?
All right, I’ve watched probably about 10 of these videos. They’re all the same the only thing that’s not covered. What do you do if the original installer did not start with a straight line and you are 20 feet from the starting point having to replace a piece
what tongues you remove
Question why do you cut the lip of the new piece? Don’t you need that to connect to old piece? Just trying to understand. I have to replace couple of pieces
🤣🤣 You fix it by removing all of it and put down tile. This shit is pure garbage. Hundreds of millions of square feet of this trash in landfills already. Say no to plastic bags but let's use plastic to build houses!!! Yeah, great logic.
Clean job 💯 would a box cutter be okay if you don’t have an oscillating tool?
Did you fill in the whole underneath the LVP? My opinion only
Should of put a liitle block in the hole in the plywood.
Yea I suppose this works. What kind of glue did you use?