In this video we carefully remove a loose tile and examine why it did not adhere well to the substrate. The tiles in this particular instance were adhered to the correct substrate but not embedded well into the thinset.
Here are some links to tools that you might find useful:
For removing the grout around the tile, use a triangle tool and a backer board scoring tool:
https://www.lowes.com/pd/Marshalltown-2-Blade-Utility-Knife/1000203997
https://www.lowes.com/pd/Marshalltown-0-875-in-Steel-Blade-Red-Plastic-Handle-Grout-Saw/1000208679
to pry the tile up, this paint scraper works well:
https://www.lowes.com/pd/Warner-Steel-Paint-Scraper-Common-3-in-Actual-3-in/1000016017
source
Talking while scraping, you might as well press the 'censored' beep button, because nobody is hearing what you're saying.
Thank you for the video! I'm currently dealing with partially loose tile around the house. I'm going to check if Home Depot has such tile before I proceed because as you mentioned, if it's partially loose, it can crack while you're removing it. Anyway I have a few questions: 1) after removing a single tile how to safely remove thinset from the back of the tile in case you need to reinstall that tile? 2) Should we do any prep work on the back of the tile prior to back buttering the tile?
I have one loose tile outside my shower, I’ll have to take it up.
I’m worried about scraping up the mortar beneath it as there is an electric wire heating system under it , and I do not want to break it ,
do I have to remove the existing mortar ? Can I not just use a gorilla glue ( liquid nail ) to re-bond the tile back to the substrate ?
GOOD. Hope you didn't pre-loosen those tiles before the demo.
My husband and I were going to rent out the big machine(sorry i dont know the name it) at home depot it would have been over $200 the space is less than 300 sq ft .. this will save us money even if it takes me all day thank you!
Thin set the floor and then back butter the tile with thin set, it’s cheap insurance against this issue
I wish you could chosen an easier tile to take out. It’s hard to watch you struggle so much however I’m glad you got that tile out! What a bear.
Excellent demo.This is exactly what I'm after today. Well done !
Talking and scraping at the same time not good for us trying to listen to you talk
I love YouTube university and I love this video. Thank you
Thank you!
Thanks! I'm already feeling better about a successful repair!
Can you please clarify what you said at 0:48? You were explaining why it could be loose, one reason was that the tile might not have been adhered properly but the second reason you said wasn't clear as the noise from the tool made it hard to hear.
I have three loose tiles. I have two questions: 1. My tiles are directly on wood. How much of old thin set do I need to get off? I can use a floor scraper and it all comes off pretty much. Do I need to get it down to bare wood again?
2. How does one level the tile to keep them all flat, no high/low spots? IN this video, they used cardboard. Any ideas? I am afraid of replacing the three and then only to have my wife stub her toe afterwards from a high spot lol.
I think the thin set was dried out and had skinned over when the tile was laid.